Russell Hobbs 18996-56 Manual download pdf (Page 66)

Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all

packaging before use.

A IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:

1 This appliance can be used by persons with reduced physical,

sensory or mental capabilities or lack of experience and

knowledge if they have been supervised/instructed and

understand the hazards involved.

•Children must not use or play with the appliance.

•Keep the appliance and cable out of reach of children.

s To avoid injury, take care handling the blades, emptying the jug,

and cleaning.

u Don’t add hot liquid (over 40°C), as it may be ejected due to

sudden steaming.

c Misuse of the appliance may cause injury.

2 Unplug the appliance before assembly, disassembly, or cleaning.

3 Don’t leave the appliance unattended while plugged in.

4 If the cable is damaged, it must be replaced by the manufacturer,

its service agent, or someone similarly qualiﬁed, to avoid hazard.

H Don’t immerse the appliance in liquid.

5 Switch oﬀ (0) before ﬁtting the jug to the motor unit.

6 Switch oﬀ (0), and wait till the blades come to a stop before removing the lid from the jug, or

removing the jug from the motor unit.

7 Don’t put utensils into the jug while the appliance is plugged in.

8 Don’t use accessories or attachments other than those we supply.

9 Don’t use the appliance for any purpose other than those described in these instructions.

10 Don’t operate the appliance if it’s damaged or malfunctions.

11 Don’t run the motor continuously for more than 2 minutes, it may overheat. After 2 minutes

switch oﬀ for at least 2 minutes, to recover.

household use only

C PREPARATION

1 Sit the motor unit on a stable, level surface.

2 Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.

3 Remove the lid.

4 Put the ingredients into the jug.

5 Don’t ﬁll past the 1500ml mark. If you do, the contents may force the lid oﬀ when you start

the motor.

6 Replace the lid.

7 Align the pips on the cap with the slots in the hole in the lid, ﬁt the cap, and turn it clockwise

to lock it.

8 Don’t run the appliance without ﬁtting the cap.

C SWITCH ON

9 Check that the speed control is set to 0.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 72

Comments to this Manuals

No comments

Russell Hobbs 18996-56 Manual Page 66

Comments to this Manuals

Related products and manuals for Blenders Russell Hobbs 18996-56