Russell Hobbs 20580 Specifications download pdf (Page 5)

C SET THE TEMPERATURE

27 Turn the temperature control to bring the setting you require next to the mark.

temperature setting guide

label marking temperature setting

j cool – nylon, acrylics, polyester •

k warm – wool, polyester mixtures • •

l hot – cotton, linen • • •

denim/jeans MAX

i do not iron

, If the instructions on the fabric label diﬀer from this guide, follow the instructions on

the label.

28 If the soleplate is at a lower temperature that the one you’ve set, the thermostat

light on top of the iron will glow, to let you know that the soleplate is heating up.

29 When the soleplate reaches operating temperature, the thermostat light will go out,

then cycle on and oﬀ as the thermostat works to maintain the temperature

C STEAM IRONING

30 Set the temperature control to S or higher – otherwise the steam might condense

on the soleplate, giving you water, instead of steam.

, When you ﬁrst want steam, you must prime the pump (opposite page).

31 Squeeze the steam trigger to produce steam, release it to stop.

32 Don’t let the reservoir empty in use, or you’ll have to prime it again when you reﬁll it.

, Steam may still escape from the iron after you release the steam button. This is

normal, don’t worry about it.

C DRY IRONING

33 You may do your dry ironing before setting the steam level (so that none of the

steam buttons glowing).

34 Alternatively, you can turn oﬀ the steam by pressing whichever steam button is

glowing (so that none of the steam buttons glow).

, It’s unlikely, but if you’re dry ironing for more than 15 minutes, the auto-shut-oﬀ

feature will operate.

C VERTICAL STEAMING

35 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.

36 Check that there’s adequate ventilation behind the fabric, otherwise moisture may

build up, causing mildew.

37 Check that there’s nothing behind the fabric that may be damaged by the steam.

38 Check that pockets, turn-ups, and cuﬀs are empty.

39 Check that the steam ready light is glowing.

40 Check that the temperature control is at S or higher.

41 Wait till the thermostat light goes out, then start steaming.

42 Hold the iron close to (but not touching) the fabric.

, Hold it well away for delicate fabrics.

43 Squeeze the steam trigger to produce steam, release it to stop the steam.

1 2 3 4 5 6 7 8

No comments

Russell Hobbs 20580 Specifications Page 5